|
|
 |
 |
 |
|
The MRF-350 receives Narrow Band RF (radio frequency) signals via the RFX-250 RF
Sensor (antenna module). The RFX-250 displays RF interference via a bright red
LED which flickers when interference is present. Simply relocate the RFX-250 out
of the interference area to resolve the problem.
You can expand the range by adding additional RFX-250 RF Sensors in remote
areas. The MRF-350 can power up to three RFX-250 RF Sensors connected in
parallel to the RF Input connector.
Universal Remote MRF350-Extended Information:
Variable IR output matches rear panel inputs
The MRF-350 is equipped
with adjustable IR line outputs. Each output can be individually matched to rear
panel IR inputs on any component that is designed to be operated by a standard
IR repeater. The outputs utilize a 3.5 mm jack.
Control Identical
Equipments
You can control six identical components or zones — Up to
fifteen MRF-350s in the same installation. The MRF-350 has six “addressable” IR
Line Outputs. For example, you can control up to six identical TVs with one
MRF-350 or route volume commands for a specific zone to a particular zone IR
input on a multi-zone pre-amp. If you have more than six identical components or
zones, up to 15 MRF-350s can be separately installed to control them—thereby
allowing up to 90 identical components or zones in one house.
The
MRF-350 is compatible with the MX-6000, MX-3000, MX-980, TX-1000, MX-950 and
MX-900, MX-880, MX-850, MX-810, MX-650, MX-450, MX-350 universal remote control.
Each can be programmed to specifically control components in a particular room
by installing a base station at each location. In operation, it’s simple: when
you select a device located in the Den, the remote only send commands to the
Den. When you select a device located in the Family Room, the remote only sends
commands to it.
IR Input for multi-zone loop through, keypads or IR
repeater systems
The MRF-350’s rear panel IR input will relay IR data
from IR repeaters or multi-zone keypads to all IR line outputs (does not support
IR routing). The 5V, 100mA output will power some keypads directly.
|
|
|
|
|
|
 |
|
 |
|
|
|
Home
Login
Cart
Register to Subscribe